DB Lab Catalogue 3rd Edition 2023

Equipment | 95
PolyQuick 260
Polyquick 260 is a pressure polymerisation unit for hot
and cold polymerisation of plastics. It can be set to a
maximum temperature of 105°C and the polymerisation
pressure can be adjusted to a maximum of 5 bar.
In automatic mode, the polymerisation time can be
preselected up to 99 hours.
A touch screen and the newly developed control panel
allow the user to set the relevant parameters quickly and
easily using self-explanatory symbols. The Polyquick
260 can also be used as a pressure compactor without
heating.
Included in delivery:
Flask bracket support
Compressed air hose, 2m
Discharge hose 2m
Hose Clip 12-20x9
£3825.00
Large hydroflask
Orthodontic cold curing acrylics require
polymerisation under pressure. This method of
polymerisation enables the vaporisation of the
monomer and condensing of the acrylic, which
will ensure a perfect fit to the plaster model.
Appliances are cured with a smooth surface
therefore reducing polishing time.
The hydroflask allows you to polymerise with the
pressure technique easily and economically.
Technical features:
Inside dimensions: 100 x 115mm
Outside dimensions: 111 x 130mm
Pressure gauge
Exhaust valve
Made of hard aluminium
Built-in thermometer
LT1315-00
£131.10
Small hydroflask
With the same features as LT1315-00,
without thermometer and slightly smaller.
Technical features:
Inside dimensions: 100 x 88mm
Outside dimensions: 111 x 105mm
Pressure gauge
Exhaust valve
Made of hard aluminium
LT1310-00
£121.30
Replacement parts
Hydroflask lid LT2300-00 £40.25
Rubber seal for lid LT2301-00 £11.05
Air valve LT2302-00 £11.05
Pressure gauge LT2304-00 £26.55
Press for hydroflask
This press is manufactured for use
with LT1310-00 and LT1315-00,
however it can be used with all
other makes of hydroflasks. Made of
pressure cast aluminium. Extremely
easy to use.
LT1311-00
£109.25
www.dblabsupplies.co.uk