Deploying an Identity Aware Network

Recommendations

Info

Extreme Networks Application NoteSteps: Select the edge switch (in this case the Summit X250e-24p with management IP address 10.127.2.18) → Click on“Enable monitoring on selected devices/ports.”Steps: Select “System defined order” for the order devices on which the setup script is run from EPICenter → Click “Next.”© 2010 Extreme Networks, Inc. All rights reserved. Identity Aware Network—Page 14
Extreme Networks Application NoteSteps: In the “Run Script Identity Management – Configuration” box: Do not change any of the default values for the globaland device specific settings that appear → Click “Next.”Steps: In “Select your run-time settings.” screen, click “Next.”© 2010 Extreme Networks, Inc. All rights reserved. Identity Aware Network—Page 15
Page 1 and 2: Extreme Networks Application NoteDe
Page 3 and 4: Extreme Networks Application NoteTa
Page 5 and 6: Extreme Networks Application Note3.
Page 11 and 12: Extreme Networks Application Noteco
Page 13: Extreme Networks Application NoteSt
Page 17 and 18: Extreme Networks Application NoteSt
Page 31 and 32: Extreme Networks Application NoteTh
Page 35 and 36: Extreme Networks Application Note©
Page 39 and 40: Extreme Networks Application NoteDe
Page 59 and 60: Extreme Networks Application Note<r
Page 61 and 62: Extreme Networks Application Note<c
Page 63 and 64: Extreme Networks Application NoteBe
Page 65 and 66:
Extreme Networks Application Note*
Page 67 and 68:
Extreme Networks Application NoteTo
show all

Deploying an Identity Aware Network

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?