Best Practices Trackside Tower and Antenna Installation - Railroad ...

More documents

Recommendations

Info

Dual Mechanical Ground Tab • Grind galvanize off tab for ground connection • Measure ground wire; gradual curve to tab. • Slide heat shrink on wire, crimp on ground lug. Heat the heat shrink after you crimp on the lug or after lug is attached to the ground tab. • Put oxidation grease on ground tab then attach lug to tab. • Spray cold galvanize on lug <strong>and</strong> tab • DO NOT USE SIGNAL GRAY SPRAY PAINT!!!
Coax Ground at Base of <strong>Tower</strong>: Both are acceptable curves for the ground wire going to the ground tab on the tower. Right picture is missing the cold galvanize spray.
Page 1 and 2: Best Practices Trackside Tower and
Page 4: Make sure you know the conversion f
Page 8 and 9: Grind area for cadweld Tower Base G
Page 10 and 11: Spray cadweld and tower with cold g
Page 12 and 13: Halo around helical pier and ground
Page 14 and 15: 12” Completed Helical Pier and To
Page 16 and 17: Mid span tool for removing sheathin
Page 20 and 21: Installer put the oxidation grease
Page 24 and 25: Tape bottom of hoisting grip
Page 27 and 28: Grind galvanize off ground tab. Gri
Page 29 and 30: Ground will be attached at these po
Page 31: If no hook is provided, attach the
Page 34 and 35: Wood removed, holes drilled, liquid
Page 36 and 37: New Building for an Intermediate
Page 38: Operational Procedure Acceptance Cr
Page 42 and 43: Ground wire is not needed when brac

Best Practices Trackside Tower and Antenna Installation - Railroad ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?