BAUER CENTERSTAR with BDS 3.0

- 5 -
Coating:
Lasting hot dip zinc coating according to DIN 50976 for all structural members including
rims.
Wheel base:
Wheel base of 4,26 m for maximum stability. Ample dimensioned wheel bases made out
of steel pipe ø 168 mm x 2,75 mm with welded-on brackets for drive motor and wheel
gear.
Drive:
- Geared motor POWER SAVER ¾ HP
- Enclosed motor, insulation class F, special moisture proof for electric connections
- High torque drive motor ¾ HP, 400 V/50 Hz with thermal overload protection
- High efficiency spur gear with flame-hardened gearwheels
- Gear ratio: 40:1
- Expansion chamber integrated in the housing
- Shaft seals with special dirt-repelling profile
- Corrosion protection by special varnish coat
Wheel gear:
- Wheel gear type UMC 740 U, ration 50:1
- Heavy duty transmission with sturdy bevel gear bearings for high torques
- Hub shaft ø 57,2 mm with protected shaft seals
- Expansion chamber with membrane
- Entry shaft seals with special dirt-repelling profile
- Corrosion protection by special varnish coat
Drive shaft:
Ample dimensioned, galvanized square pipes 25 x 3 mm
Coupling parts with elastic element for troublefree start
Drive shaft with protecting pipe against corrosion and to avoid accidents, meeting the
international safety regulations.
Tyres:
High-flotation tyres for irrigation
Dimension: 14,9 – 24; 8 Ply
New tyres
Rim size: W 12 x 24 for 8 wheel studs
Hole circle diameter: 8"
Rims hot dip galvanized
../6