2005 Skareb Service Manual - Fahrrad Kaiser GmbH

More documents

Recommendations

Info

Bushing Removal & Installation Bushing Removal (Note: use appropriate removal ring that corresponds to the leg diameter of the fork being repaired) Leg Diameter Answer Kit # 25.4mm (1”) 85-5191 28.6mm (11/8”) 85-5189 30mm 85-5194 32mm 85-5192 Bushing Removal Tool Components A. Slide Hammer B. Threaded Handle C. Slide D. Threaded Shaft E. Removal Ring Bushing Removal Tool Assembly 05 SKAREB SERVICE MANUAL Page 22 REV NC
Bushing Removal Instructions A. Install 25.4mm Removal ring on the shiny, smaller diameter threaded shaft. Be sure to install the ring with the tapered, chamfered end first, followed by the long slide tube. This tapered end leads the tool through the bushing. B. Start the procedure by removing the Dust/Wiper seal with a screwdriver, prying it out. C. Insert Removal tool past the upper bushing and then stop. It is important to pull one bushing out at a time. Push the slide on the threaded shaft down towards the removal ring. Hold the casting with one hand and the slide hammer with your other hand. Now move the slide hammer in a motion away from the casting and repeat this action until the bushing comes out. D. For all other leg diameters: use the larger diameter (dark colored) threaded shaft and repeat steps A-C. Bushing Removal (CONT.) Bushing Installation (Note: Sizer kits listed in above chart contain the sizers needed for each specific leg diameter.) Bushing Installation Tool Components 1. Installation Mandrel 2. Threaded Rod w/nuts 3. Sizer rings 4. Spacer 5. Washer 6. Nut (1) (2) (3) (4) (3) (5) (6) 05 SKAREB SERVICE MANUAL Page 23 REV NC
Page 1 and 2: 2005 Skareb Service Manual Rev NC 0
Page 3 and 4: INTRODUCTION This manual is intende
Page 5 and 6: FRONT SUSPENSION TERMINOLOGY (CONT.
Page 7 and 8: FRONT SUSPENSION TERMINOLOGY (CONT.
Page 9 and 10: Removal of Rebound Damping Assembly
Page 11 and 12: 4. Re-install the air push rod, pos
Page 13 and 14: 16mm Hex shaped Volume control nut
Page 15 and 16: Complete Remote Lock out Assembly B
Page 17 and 18: IT System Disassembly Instructions
Page 19 and 20: Troubleshooting Tips continued This
Page 21: Reassembly of the IT System 1. It i
Page 25 and 26: Bushing Installation (CONT.) 4. Sli
Page 27 and 28: TROUBLESHOOTING (CONT.) Symptom Cau
Page 29 and 30: Skareb Service Kits Model Comp Elit

2005 Skareb Service Manual - Fahrrad Kaiser GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?