2005 Skareb Service Manual - Fahrrad Kaiser GmbH

TROUBLESHOOTING
Symptom Cause Solution
Air Loss Schrader Valve leaks
Air Cap O-ring leaks
Air Piston leaks
Air Top Cap leaks
Oil leaks from
Wiper Seals Seal not seated properly
Oil leaks from
bottom of
Casting
Nicks or scratches on
inner legs
Too much Semi Bath oil
Wear
Tighten Valve core, replace bad parts as
needed. 10
Make sure O-ring is seated properly,
replace parts as needed. 9
Check oil volume on top of piston, replace
parts as needed. 9
Check O-ring, tighten cap to proper
Torque, replace parts as needed. 9
Remove Casting from Inner Legs, reinstall
or replace seals 8
Replace Crown/Steerer/Inner Leg
Assembly 8
Follow instructions for removal and
installation of Outer Casting 13
Remove Casting from Inner Legs, reinstall
or replace seals 8
Rebound damper shaft
leaks Replace Rebound Damping assembly 9
Rebound damper shaft Oring
damaged
Compression Rod Bolt
leaks
Lack of Travel Tight Bushings
Replace O-ring on threaded end of
Rebound Damping assembly 9
Check O-ring on bolt to see if it is
damaged and then reinstall 8
Resize bushings or replace with new ones
if damaged 22
Hydraulic lock out Replace Rebound Damping assembly 9
Semi Bath oil volume
Damper oil volume
Fork alignment
Loss of SPV
damping SPV valve not functioning
Damper oil volume
Follow instructions for removal and
installation of Outer Casting 13
Check oil level, Replace Rebound
Damping assembly if needed 12
Visually inspect fork, call Answer
Products Customer Service 2
Inspect for damage, check valve gap,
replace assembly if needed 8
Check oil level, refer to "Oil leaks from
bottom of Casting" 12
Rebound knob does not
turn Replace Rebound Damping Assembly 9
Loss of SPV air pressure
Refer to "Air Loss- Schrader valve leaks
and Air Cap O-ring Leaks" 9
Service
Manual
Page
05 SKAREB SERVICE MANUAL Page 26 REV NC