MN 103 - ECG

Comfortably sit down, place your feet on the massage rollers and using the dial switch set
the massage mode to:
1. warm bath + vibration massage + bubble massage + infra-radiation
If you wish to carry out the foot massage in a warm water bubble bath.
23
EN
2. warm bath + blowing
If you wish to carry out the foot massage in pleasant warm water.
The aromatic diffuser provides pleasant aroma therapy, because the fragrance is optimally
dispersed by the air current. Put a few drops of an aromatic oil on the cotton pillow
and then place the pillow on the aromatic diffuser and insert it back. It can also be used
as a nail dryer.
3. vibration massage + infra radiation
If you want to massage your feet in a water bath (without temperature control).
0. off
After completing the massage fi rt turn the switch to the position "0", and only then remove
your feet and disconnect the product from the power socket.
Do not forget that you must not stand up in the product!
When pouring in the water tilt the product, e.g. above the bath tub so that the water can run
out the spout.
CLEANING AND MAINTENANCE
The massage unit in a health device, not a wash basin. Before the massage wash your feet in
clean soft water. Settled particles clog the air jets and worsen the bubble effect.
Before cleaning always pull the power cord out of the socket and wait until the product has
completely cooled down.
After using the massage machine simply rinse out with clean water. Never submerge the
entire product under water!
To clean the surface of the product use a damp cloth. DO NOT USE any chemical cleaning
agents / abrasive cleaning agents.
You can store the massage machine only after the main switch has been turned off, it is disconnected
from the power socket, is without water and after it has completely cooled down.
Before storage wind the power cord around the winding holder.