iTerra Elite Quick Start Guide - The Imaging Systems Group Inc.
iTerra Elite Quick Start Guide - The Imaging Systems Group Inc.
iTerra Elite Quick Start Guide - The Imaging Systems Group Inc.
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
IV. OUTPUT VIA BACK<br />
Smearing<br />
Press Button 2 once<br />
Display should read “Fanfold Print Control<br />
Exit: Back Status:<br />
Smear ”<br />
Press Button 3 once to save change<br />
Display should read “Fanfold Print Control<br />
Exit: Back Status:<br />
Smear *”<br />
Press Button 4 once to put printer back<br />
ONLINE<br />
Display should read “Cycle Printer Power<br />
Check Print Quality”<br />
Cycle the printer’s power<br />
Run Test Plot to check quality of plot<br />
Repeat these steps until image quality is<br />
acceptable<br />
Press Buttons 6 & 7 at same time<br />
Display should read “Fanfold Print Control”<br />
Press Button 1 once<br />
Display should read “Fanfold Print Control<br />
Exit: Back Status: Good *”<br />
(Default)<br />
NOTE: Ensure you are only changing the Status for where your media is exiting the printer.<br />
Jamming<br />
Press Button 2 twice<br />
Display should read “Fanfold Print Control<br />
Exit: Back Status:<br />
Stall”<br />
Press Button 3 once to save change<br />
Display should read “Fanfold Print Control<br />
Exit: Back Status: Stall<br />
*”<br />
Press Button 4 once to put printer back<br />
ONLINE<br />
Display should read “Cycle Printer Power<br />
Check Print Quality”<br />
Cycle the printer’s power<br />
Run Test Plot to check quality of plot<br />
Repeat these steps until JAMMING in front of fuser<br />
stops<br />
_________________________________________________________________________________________________________________________<br />
PAGE 50 --- <strong>iTerra</strong> <strong>Elite</strong> <strong>Quick</strong> <strong>Start</strong> <strong>Guide</strong> © 2008 iSys-<strong>The</strong> <strong>Imaging</strong> <strong>Systems</strong> <strong>Group</strong> <strong>Inc</strong>.