TCS Injector System - Imperialdental.net
TCS Injector System - Imperialdental.net
TCS Injector System - Imperialdental.net
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
IMPFERIAL TRADING LTD. TEL: (800) 733-7490<br />
72-59 KISSENS BLVD (718) 793-7490<br />
FLUSHING, NY 11367 FAX: (718) 793-9831<br />
Use a low speed lathe machine with a light touch and always remember that<br />
during polishing, one should move the case against the rag wheel, in one<br />
direction only.<br />
XIV, PACK THE <strong>TCS</strong> FLEXIBLE CASE<br />
After the usual disinfecting procedure, place the case in the <strong>TCS</strong> bag with water<br />
and seal.<br />
SPECIAL INSTRUCTIONS<br />
FOR <strong>TCS</strong> TOTALLY NATURAL DENTURES<br />
Keep tube with the Totally Natural materials dry for approximately at 122-140<br />
degrees Fahrenheit (50-60 degrees Centigrade) at all times, or at least 1-2 hours prior<br />
to injection<br />
Preheat the tube & the flask at 400-450 degrees Fahrenheit (204.4- 232.2 degrees<br />
Centigrade) for at least 10 minutes.<br />
Put tube with the Totally Natural materials in the cylinder for 15 minutes at 480- 510<br />
degrees Fahrenheit (248.8- 265.5 degrees Centigrade) to melt the materials.<br />
Inject when flasks are still hot (Please wear gloves)<br />
If necessary, the six anterior pontics may need a cold cure acrylic mask if too<br />
transparent.<br />
Proceed with finishing and polishing, same as that of conventional acrylic. No<br />
special burs or instruments are needed.<br />
www.imperialdental.<strong>net</strong> 11