02.02.2013 Views

OM, HUSQVARNA, YTH20K46, 2011-02, 532441748, NAen ...

OM, HUSQVARNA, YTH20K46, 2011-02, 532441748, NAen ...

OM, HUSQVARNA, YTH20K46, 2011-02, 532441748, NAen ...

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

SERVICE AND ADJUSTMENTS<br />

TO REPLACE HEADLIGHT BULB<br />

• Raise hood.<br />

• Pull bulb holder out of the hole in the backside of the<br />

grill.<br />

• Replace bulb in holder and push bulb holder securely<br />

back into the hole in the backside of the grill.<br />

• Close hood.<br />

INTERLOCKS AND RELAYS<br />

Loose or damaged wiring may cause your tractor to run<br />

poorly, stop running, or prevent it from starting.<br />

• Check wiring. See electrical wiring diagram in the Repair<br />

Parts section.<br />

TO REPLACE FUSE<br />

Replace with 20 amp automotive-type plug-in fuse. The<br />

fuse holder is located behind the dash.<br />

TO REMOVE HOOD AND GRILL ASSEMBLY<br />

(See Fig. 35)<br />

• Raise hood.<br />

• Unsnap headlight wire connector.<br />

• Stand in front of tractor. Grasp hood at sides, tilt toward<br />

engine and lift off of tractor.<br />

• To replace, reverse above procedure.<br />

070<strong>02</strong><br />

Fig. 35<br />

HOOD<br />

HEADLIGHT<br />

WIRE<br />

CONNECTOR<br />

23<br />

ENGINE<br />

TO AD JUST THROTTLE CON TROL CABLE<br />

The throttle control has been preset at the factory and<br />

ad just ment should not be necessary. If adjustment is neces<br />

sary, see engine manual.<br />

TO AD JUST CHOKE CON TROL<br />

The choke control has been preset at the factory and ad justment<br />

should not be necessary. If adjustment is necessary,<br />

see engne manual.<br />

TO ADJUST CARBURETOR<br />

Your carburetor is not adjustable. If your engine does not<br />

operate properly due to suspected carburetor problems,<br />

take your tractor to an authorized service center for repair<br />

and/or adjustment.<br />

TRANSMISSION<br />

REMOVAL/RE PLACE MENT<br />

Should your transmission require removal for service or<br />

re place ment, it should be purged after reinstallation and<br />

before operating the tractor. See “PURGE TRANS MIS SION”<br />

in the Operation section of this manual.

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!