Curriculum Vitae Thenkurussi (Kesh) Kesavadas - Mechanical and ...

PUBLICATIONS
Book
1. Banerjee, P., and Kesavadas, T., (Editors) “Industrial Virtual Reality: Manufacturing
and Design Tool for the Next Millennium”, ASME Press, 1999.
Book Chapters
1. Kesavadas, T., and Balajapalee, A., “Advances in Haptic Simulations in Design and
Manufacturing,” Handbook of Industrial Information Technology, CRC Press,
Chapter 67, 2004.
2. Sheridan, M.F., Bloebaum, C.L., Kesavadas, T., Patra, A.K, and Winer, E.,
“Visualization and Communication in Risk Management of Landslides,” in C.A.
Brebbia (editor), Risk Analysis III, WIT Press, Southampton, pp. 691-701, 2002.
3. Kesavadas, T., Khor, C., Subramaniam, H., Taluk, D., "Programming of a Virtual
Robot Assisted by a Neural Network for Manufacturing Applications" ASME
Intelligent Engineering Systems through Artificial Neural Networks. v 7 pp. 879-884,
1997.
4. Kesavadas, T., Kuo, R J., Cannon, D J., "Intelligent Robotic Die Polishing System
Using A Neural Network" ASME Intelligent Engineering Systems Through Artificial
Neural Networks. v 2 pp. 803-808, 1992.
Journal Papers (under revision or review)
1. Kim, Y.-S., Britto, R., and Kesavadas, T., “Remote Haptic Diagnosis of Arterial
Pressure Pulse using Two Different Touch Interfaces: A Phantom and a Low-Cost
Vibrator” IEEE Transaction on System, Man and Cybernetics - Part A (submitted
after major revision January 2008)
2. Srimathveeravalli, G., and Kesavadas, T., “Evaluation of Training Techniques for
Interpersonal Skill Transfer and Development of a Prototype Framework Using
Haptic Attributes” under review, IEEE Transactions on Haptics (submitted January
2008)
3. Srimathveeravalli, G., Kumar A., and Kesavadas, T., “Comparative Study: Virtual
Fixtures and Shared Control for Rehabilitation of Fine Motor Skills” Submitted to
ASME Journal of Computers and Information Sciences in Engineering – (submitted
September 2007 - recommended for acceptance as an applications paper)
Last Revised: 7/10/2008 20