TRANSPONDER GUIDE 2008 - STRATTEC Security Corporation
TRANSPONDER GUIDE 2008 - STRATTEC Security Corporation
TRANSPONDER GUIDE 2008 - STRATTEC Security Corporation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
On-BOaRD<br />
pROGRaM 7 2001+ fORD fOCUS, fORD ESCapE<br />
2001+ MaZDa TRIBUTE OnlY<br />
ORIGInaTE nEw MaSTER KEY:<br />
Two working keys are required to program<br />
additional keys with this on-board<br />
programming method.<br />
aDD KEY: (Requires two working keys)<br />
1. put the existing key into the ignition.<br />
2. Turn the ignition On, then turn it Off again.<br />
3. within five seconds, take out the existing key<br />
and put in a second key, turning it to On and<br />
back Off.<br />
On-BOaRD<br />
pROGRaM 8 2002+ TOTOTa, lEXUS<br />
Keys can be programmed using the Code-Seeker<br />
on most 32 bit systems. The 2003 and 2004 Sequoia<br />
requires flashing.<br />
TO DElETE all BUT OnE KEY fROM THE UnIT:<br />
1. Simultaneously depress and release brake and<br />
accelerator pedals 1 time.<br />
2. Insert an existing master key into the ignition cylinder.<br />
Do not turn the key from the Off (lOCK) position.<br />
3. within fifteen seconds of inserting the key, depress and<br />
release the accelerator pedal six times.<br />
4. within twenty seconds of completing the above step,<br />
depress and release the brake seven times.<br />
5. The security light will flash, indicating all keys other<br />
than the one being used have been deleted.<br />
6. Remove the key from the ignition cylinder within ten<br />
seconds.It will be the only key still programmed to work.<br />
4. within ten seconds, put in the new key and turn it<br />
on. after one second, turn it Off.<br />
5. The security light will glow for three seconds. This confirms<br />
the new key has been programmed successfully.<br />
aDD DUplICaTE KEY:<br />
Requires one working Toyota/lexus Master key.<br />
1. Make sure all doors and windows are closed<br />
2. Insert Master key into the ignition cylinder.<br />
3. Cycle the ignition cylinder from On to Off five times.<br />
4. Open and close the driver side door six times.<br />
5. Remove the Master key and insert the new<br />
duplicates key.<br />
6. TURn THE IGnITIOn CYlInDER On.<br />
7. The new key will be registered after 60 seconds. The<br />
THEfT light on the dashboard will go out, indicating that<br />
the programming has been completed.<br />
7