JOINT FLEET MAINTENANCE MANUAL - Submarine Maintenance ...

Section Area of Responsibility Responsibility
VI-4.8.d Shipboard Electromagnetic
Compatibility
VI-8.2.3 Miniature/Micro-miniature
Electronic Repair Program
VI-9.2.5 Metrology and Calibration
Program
VI-11.5.3 Maintenance, Repair and
Overhaul of Service Craft,
Landing Craft and Small
Boats
FWD-B-33
COMUSFLTFORCOMINST 4790.3 REV C
• Ensure EMS PMS is conducted
• Request EMI survey within six months of
deployment or when any new indications of
EMI occur
• Transmit EMC departure message to
cognizant activities
• Maintain up-to-date file of EMI/EMC
information
• Establish 2M program under cognizance of
Electronics Material Officer and Combat
Systems Officer
• Maintain certified 2M stations and technicians
• Screen and repair all CCAs/Ems
• (Aircraft Carriers) establish MTRF with an
overall coordinator
• (Aircraft Carriers) maintain an active MTRF
• Maintain high degree of TAMS calibration
readiness
• Appoint a calibration coordinator
• Ensure only operational TAMS are submitted
for calibration
• Perform repair of TAMS within capability of
Ship’s Force
• Maintain calibration readiness goal
• Coordinate planning aspects of craft and/or
boat overhauls with TYCOM/ISIC
• Prepare and submit overhaul progress reports
• Ensure enough trained personnel are assigned
to on-site monitoring of crafts and boats
• Fulfill responsibilities for safety of craft and
personnel
VI-12.3.2.2 Degaussing • Maintain ship’s installed degaussing system
• Maintain ship’s degaussing folder
• Submit a minor Departure From Specification
VI-12.4.1.2 Degaussing (Submarines
without degaussing systems)
if range checking requirements are not met
• Ensure magnetic signature minimized by
periodic check ranging
• Inform ISIC of unsat ranging
• Maintain ship’s degaussing folder
• Undergo flash deperming as directed
• Before flash deperming prepare ship’s
equipment and off-load sensitive material
• Submit a minor Departure From Specification
if range checking requirements are not met