STIHL RMA 370

N Use the height adjusting lever (1) to
raise the mower – the lever is
pushed forwards.
Lower cutting height:
N Use the height adjusting lever (1) to
push the mower down – the lever is
pushed to the rear.
N Push the height adjusting lever (1)
against the housing until the
detents (2) engage.
The chosen height setting is indicated by
the front detent (3).
RMA 370
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
N Insert the mains plug (1) in the wall
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
1
2
3901BA015 KN
3901BA019 KN
Charging the Battery
English
The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
the first time.
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between 41°F (5°C) and 104°F (40°C).
N Push the battery (1) into the
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
2
3901BA009 KN
15