Operator's Manual - ManageMyLife
Operator's Manual - ManageMyLife
Operator's Manual - ManageMyLife
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
HOW TO USE YOUR<br />
WASHER<br />
PRESSURE<br />
if you have any problems operating your pressure<br />
washer, please call the pressure washer helpline at<br />
1-800-222-3136.<br />
Pressure Washer Location<br />
Pressure Washer Clearance<br />
• Keep at least 5 ft. (152 cm) clearance on all sides of<br />
pressure washer including overhead,<br />
Place pressure washer in a well ventilated area, which<br />
will allow for removal of deadly exhaust gas. DO NOT<br />
place pressure washer where exhaust gas could<br />
accumulate and enter inside or be drawn into a<br />
potentially occupied building. Ensure exhaust gas is<br />
kept away from any windows, doors, ventilation<br />
intakes or other openings that can allow exhaust gas<br />
to collect in a confined area. Prevailing winds and air<br />
currents should be taken into consideration when<br />
)ositioning pressure washer.<br />
WARNING<br />
1<br />
To Start Your Pressure Washer<br />
To start your engine-powered pressure washer for the<br />
first time, follow these instructions step-by-step. This<br />
starting information also applies whenever you start<br />
the engine after you have let the pressure washer sit<br />
idle for at least a day.<br />
1. Place pressure washer near an outside water<br />
source capable of supplying water at a flow rate<br />
greater than 3.7 gallons per minute and no less than<br />
20 PSI at pressure washer end of garden hose.<br />
2. Check that high pressure hose is tightly connected<br />
to spray gun and pump. See "Assembling Your<br />
Pressure Washer" for illustrations.<br />
3. Make sure unit is in a level position.<br />
4. Connect garden hose to water inlet on pressure<br />
washer pump. Turn ON water.<br />
CAUTION<br />
* Damage to equipment will result from failure to follow<br />
this instruction.<br />
.<br />
6.<br />
Squeeze trigger on gun to purge pump system of<br />
air and impurities.<br />
Attach nozzle extension<br />
hand.<br />
to spray gun. Tighten by<br />
Operate pressure washer ONLY outdoors,<br />
Keep exhaust gas from entering a confined area through<br />
windows, doors, ventilation intakes or other openings,<br />
DO NOT operate pressure washer inside any building or<br />
enclosure, even if doors or windows are open.<br />
.<br />
\<br />
Choose ProjectPro TM nozzle you want to use, pull<br />
back on collar of nozzle extension, insert nozzle<br />
and release collar. Tug on nozzle to make sure it<br />
is securely in place. See "How to Use<br />
ProjectPro TM Nozzle System".<br />
8. Engage trigger lock to spray gun trigger.<br />
Typical<br />
Washer<br />
Pressure<br />
Shown<br />
Trigger Lock<br />
Exhaust Port<br />
10