26.09.2014 Views

Curl Styler.book - Wella

Curl Styler.book - Wella

Curl Styler.book - Wella

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

<strong>Curl</strong> <strong>Styler</strong>.<strong>book</strong> Seite 27 Donnerstag, 24. November 2011 5:31 17<br />

4.3 Storage of appliance<br />

The appliance has a loop 10<br />

which allows it to be hung up.<br />

TIP: Hang up the appliance so<br />

that the spacers 2 are against<br />

the wall; this will stop the appliance<br />

getting scratched.<br />

5 Cleaning and Care<br />

To ensure the proper functioning and full performance<br />

of the <strong>Curl</strong> <strong>Styler</strong>, you should clean the appliance<br />

at regular intervals. The <strong>Curl</strong> <strong>Styler</strong> should<br />

always be protected from dust, dirt and lint.<br />

IMPORTANT: The power plug of the appliance must<br />

always be disconnected before cleaning.<br />

5.1 Cleaning appliance<br />

– Occasionally wipe the appliance with a slightly<br />

damp cloth and then rub dry.<br />

5.2 Cleaning round brushes<br />

The round brushes are cleaned as required.<br />

– Detach the round brush from the appliance (see<br />

page 26).<br />

– Make sure that the bristles of the round brushes<br />

do not get bent. Retract the bristles of the small<br />

and medium-sized round brush to clean the<br />

metal tube.<br />

– Clean the accessories with warm water and a little<br />

detergent.<br />

– Then rinse with clean water and dry well.<br />

6 What to do when ...<br />

... the appliance switches itself off?<br />

– The overheat protection has tripped. Make<br />

sure that the suction grille is not covered up<br />

during usage.<br />

Move the switch 8 to “0” and wait a few minutes.<br />

Then switch the appliance back on.<br />

ENGLISH<br />

27

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!