GILES 202 - Graupner

Accessory pack I:
Engine bulkhead
Undercarriage braces, 2 off
Fueltank support former
Fueltank support
Tension springs, 1 x 9.0 x 140, 5 off
Silicone hose, 10 x 14 x 200
Accessory pack II: (canopy)
M4 captive nut
M4 x 20 socket-head cap screw
Brass tube, 5 Ø x 4.05 Ø x 50
Accessory pack III: (cowl retention)
Birch ply panel, 215 x 4
Washers, 3.2 Ø x 8 Ø x 0.5, 10 off
Self-tapping screws, V2A, 2.9 Ø x 9.5, 10 off
Socket-head cap screws, M5 x 90 (spinner attachment)
Accessory pack IV:
Brass sleeves, M3 internal thread, 2 off
) Rudder
Self-locking nuts, M3, 2 off
) linkage
Horn lugs, white, 2 off )
GRP hinge lugs, 2.5 mm thick, 3 off (rudder hinges)
Screws, M2 x 12, 2 off
Self-locking nuts, M2, 2 off
Maxi-lever
Clevises, M3, 6 off
Nuts, M3, 6 off
Bored M3 pillar, aluminium, 6 off
Stranded steel cable, 0.8 Ø x 2000 (rudder linkage)
Braided cable, 19 x 0.1 Ø x 2000 (steerable tailwheel linkage)
Aluminium tubes, 2 Ø x 1.6 Ø x 80, 4 off (cable crimp sleeves, Fig. 92)
S-hooks, 2 off (steerable tailwheel linkage, Fig. 98)
Cable ties, 10 off
Support plates, 10 off
) to secure and support
) cable looms etc.
Accessory pack V: (throttle servo mount / throttle linkage)
Plywood plate, 100 x 35 x 5
Self-tapping screws, 2.9 Ø x 9.5, 2 off
Servo mounts, plastic, 2 off
Studding, M2, 2 off
Pushrod connector, M2 self-locking nut, M3 studding - 1 each (throttle pushrod)
19