SharkVAC XL ? / e.VAC PRO - Hayward

More documents

Recommendations

Info

Weight (w/o cable) 23 lb (10.45 Kg) Cable Length, Type 60 ft (18.29 m) Materials High Impact ABS - Metal Parts of Non-Ferrous Stainless Steel Motor Unit Pump Drive PCB Speed (rpm) 2700 55 - Voltage 24 VDC 22 VDC 5 VDC Current (amp) 2.62 A 0.63 A - Waterproof Sealing Motor Housing Overload Protection Triple Redundant Radial Shaft Seals & O-ring Sealed, Watertight, High Impact Polypropylene Electronic Overload Monitoring with auto-shutoff Filter Type Media Removable, Re-Usable, Pleated Element Cartridge Pleated Cellulose/Polyester Blend Cleaning Routine Control Type Cleaning Cycle Adaptive Seek Control Logic (ASCL®) Microprocessor Full Cycle 3 hours Drive System Direct Drive w/Polyurethane Drive Track & Acetal/Stainless Steel Bearing System Power Supply Input Primary Voltage Output Secondary Voltage Rated Output Current Weight 110-120 VAC 24 VDC 4 A 8.3 lbs (3.8 Kg) Shipping Carton Dimensions (mm) Length Width Height 24 in (620 mm) 17 in (440 mm) 30 in (752 mm) Shipping Weight with Caddy 49 lb (22.3 Kg) without Caddy 43 lb (19.5 Kg) USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 18
IMPORTANT SAFETY INSTRUCTIONS This robotic swimming pool cleaner has been manufactured with the highest degree of care and concern for safety. We suggest the following safety precautions become part of your pool safety regulations: SAVE THESE INSTRUCTIONS 1. ALWAYS PUT THE MACHINE INTO THE WATER BEFORE connecting it to the GFCI protected electrical outlet. 2. IT IS IMPORTANT FOR SWIMMERS’ SAFETY TO REMOVE THE UNIT IMMEDIATELY FOLLOWING USE. THIS CAN ALSO IMPROVE THE OPERATING LIFE OF YOUR CLEANER. 3. BE CERTAIN THE machine IS ONLY PLUGGED into a grounded electrical outlet equipped with an approved and properly operating ground fault circuit interrupter (GFCI). 4. DO NOT HANDLE MACHINE WHILE IT IS PLUGGED INTO THE ELECTRICAL OUTLET. 5. DO NOT USE AN EXTENSION CORD. THIS COULD CREATE A SAFETY HAZARD AND/OR DAMAGE YOUR CLEANER. 6. ALWAYS STAY OUT OF THE POOL WHILE CLEANER IS IN OPERATION. 7. NEVER ALLOW PLUG TO ENTER THE POOL. 8. DO NOT OPERATE THE MACHINE OUT OF WATER. THIS WILL DAMAGE THE MOTOR SEAL AND VOID THE WARRANTY. 9. DO NOT DRAG THE MACHINE OUT OF THE POOL AGAINST THE SIDE WALL. THIS COULD DAMAGE UNIT AND/OR YOUR POOL WALL. 10. DO NOT BURY CORD. DO NOT OPERATE CLEANER WITH DAMAGED CORD. REPLACE DAMAGED CORDS IMMEDIATELY. WARNING - TO REDUCE THE RISK OF INJURY; DO NOT PERMIT CHILDREN TO USE THIS PRODUCT UNLESS THEY ARE CLOSELY SUPERVISED AT ALL TIMES. 11. If the supply cord is damaged it must be replaced by the manufacturer, service agent, or similarly qualified persons in order to avoid a hazard. While the cleaner has been made to operate as safely as possible, we suggest you exercise reasonable care in the handling of the vacuum and inspect the electrical cord frequently for damage or wear, as with any other electrical appliance. After use, remove the unit and rinse with fresh water and remove any twists that may be present in the cord. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 19
Page 1 and 2: SharkVAC XL / e.VAC PRO by Owner
Page 3 and 4: WARNING - Read and follow all instr
Page 5 and 6: CONSUMER INFORMATION AND SAFETY DAN
Page 7 and 8: GENERAL OPERATING INSTRUCTIONS Take
Page 9 and 10: 1. Power Supply 2. On/Off Switch 3.
Page 11 and 12: Clean the filter cartridge after ea
Page 13 and 14: 6. Return the filter bucket assembl
Page 15 and 16: OUT OF WATER SENSOR To better prote
Page 17: TROUBLESHOOTING If the cleaner fail
Page 21 and 22: USE ONLY HAYWARD GENUINE REPLACEMEN
Page 23 and 24: ISRC9740XLN Rev -3 SharkVAC XL / e.
Page 25 and 26: AVERTISSEMENT - Pression dangereuse
Page 27 and 28: AVERTISSEMENT - LISEZ CES CONSEILS
Page 29 and 30: 8. Une fois la piscine nettoyée, m
Page 31 and 32: INSTRUCTIONS POUR LE CHARIOT - VOIR
Page 33 and 34: 5. Pour enlever les cartouches de f
Page 35 and 36: Escalade des parois LIGNE D’EAU P
Page 37 and 38: CONSEILS IMPORTANTS Ne laissez pas
Page 39 and 40: Poids (sans câble) Longueur du câ
Page 41 and 42: GARANTIE LIMITÉE HAYWARD ® Tous l
Page 43 and 44: ENREGISTREMENT DU PRODUIT (À conse
Page 45 and 46: ADVERTENCIA - Lea y siga todas las
Page 47 and 48: CONSERVE ESTAS INSTRUCCIONES GARANT
Page 49 and 50: INSTRUCCIONES DE OPERACIÓN GENERAL
Page 51 and 52: 1. Suministro eléctrico 2. Interru
Page 53 and 54: Limpie el cartucho del filtro despu
Page 55 and 56: 6. Vuelva a colocar el conjunto del
Page 57 and 58: SENSOR FUERA DEL AGUA Para proteger
Page 59 and 60: SOLUCIÓN DE PROBLEMAS Si el limpia
Page 61 and 62: INSTRUCCIONES DE SEGURIDAD IMPORTAN
Page 63 and 64: 1 RCX97471SB 10 RCX97415 20 RCX5900
Page 65: ISRC9740XLN Rev -2 65

SharkVAC XL ? / e.VAC PRO - Hayward

Create successful ePaper yourself

Delete template?

Save as template?