2790 Bedienungsanleitung 2 Operating Instructions 12 Mode d ...

Ba_2790_D_GB_F_E_I.qxd 14.06.2006 08:28 Seite 20
ENGLISH
!
"
Messages
The scale sets the value
zero automatically when
it is switched on.
The zero range at poweron
is -5% ....+15% of the
weighing range.
If the scale is outside the
set tolerance range, the
display shown adjacent
appears.
Parts weight too small
Zeroing not possible
Elimination
! Either take the load off
the platform or press the
key to activate the calibrated
zero point.
" There is a mechanical
or electrical fault.
The scale is not suitable
for these parts.
The zero limit has been
exceeded or undershot.
Taring is not possible
Print not permitted on
over- or underload
Switch to lbs
deactivated
Cannot tare the zero
display or negative values.
Place an object on the
scale / remove an object
from the scale.
Activation is described on
Pages 18/19.
In case of other error messages,
please contact your
SOEHNLE service
125 mm
77mm
82,6 mm
306 mm
Technical data
• Housing made of anodised aluminium
• Protection class IP 65, dust-proof and splash-proof.
• Operated by means of a tactile keypad.
• Plug-in power supply 100-240V, 57-63Hz
• Operating temperature -10° ..... +40° C
• Storage temperature -20° ..... +60° C
• Zero range -1 %... +3 % of the weighing range (max.)
• Zero range at power-on -5% ...+15% of the weighing
range.
• RS 232 (V24) interface for printer or IT connection.
For a description of the interface, please contact your
Soehnle service partner.
20
143,7 mm