F - Tormatic

GB
Diagnostic read-out
When the operator is at rest, it is possible to call up a diagnosis function. After pressing the STOP button for approx. 3 s, the control system issues a sequence
of letters and numbers, one after the other. This commences with "A", then step 1 is displayed with the subsequent status, then step 2 with the subsequent
status etc.
Displayed step Status Type of function
A
Start
1 Last error
0 No error
3 Stop A
5 Stop B
7 Overcurrent
2 Last end-of-travel position
0 CLOSE end-of-travel position
3 Intermediate end-of-travel position
6 Search cycle
9 OPEN end-of-travel position
3 RH-LH operation
0 RH operation (factory setting)
1 LH operation
4 Direction of travel
0 CLOSE direction of travel
9 OPEN direction of travel
5 Force in OPEN direction
0 - 9 Menu setting
6 Force in CLOSE direction
0 - 9 Menu setting
7 Learning cycle
0 Learning cycle not completed
9 Learning cycle completed
8 Operating mode
0 Semi-automatic (hold to run control)
1 Fully automatic (impulse operation)
2 Traffic light operation
3 Automatic closing
4 Automatic closing with reduced open phase
- Count of cycles counter
. . . The numerical display shows the number values starting with the
highest decimal point and working down to the lowest.
- End
Dear Customer,
Terms of the Warranty
During production the garage door operator you well as any alterations or modifications carried out The customer must bear our costs.
have purchased has undergone various checks by to the operator and accessory parts by the This warranty is only valid in conjunction with the
the manufacturer to ensure that it is of impeccable customer. The same shall also apply for damage signed invoice and commences on the day of
quality. incurred during transit or as a result of force delivery. The manufacturer guarantees that the
Should this operator or part of it prove to be of no majeure, external influences or natural wear as product is free of defects.
or limited use as a result of proven material or well as special atmospheric stresses. We cannot The warranty is granted for a period of 24 months,
manufacturing defects, we shall rectify this, at our accept any liability following alterations or in as far as the verification overleaf has been
discretion, by means of a free-of-charge repair or modifications of functional parts carried out by the properly filled out. Otherwise the warranty shall
replacement. customer. We must be notified of any defects expire 27 months after the date of manufacture.
We shall not accept any liability for damage as a immediately in writing; on request, the parts in
result of unsatisfactory fitting and installation, question shall be sent to us. We shall not bear the
improper putting into service, incorrect operation costs for dismantling and installation, freight and
and maintenance, excessive use or overloading as carriage. If a complaint is proven to be unjustified,
Retain these installation, operating and maintenance instructions for the full duration of the operator's service life!