TV Explorer HD ATSC manual - Promax

USER’S MANUAL. TV EXPLORER HD ATSC5.22 TV Operating ModeWhen pressing the [10] key from any mode of operation the TV EXPLORERHD ATSC accedes to the TV mode, and tries to demodules on the monitor the currentlyvideo signal on tune.In the monitor will appear the TV picture with a window on the lower part to show,for five seconds whenever the signal is analogue; the channel number, the frequency,the active channel set, the colour system, the TV standard and the saturation level(SYNC OK / SYNC FAIL).EnglishFigure 59.- Analogue channel monitoring.If it is a digital television signal (DTV) on screen appears, for about some seconds,the following parameters:The top data box shows the tuned CHANNEL data: number or satellite name,frequency, active channel plan and satellite downlink frequency.The following data box shows the VIDEO data: type of video coding (MPEG-2 orMPEG-4), video bit rate, profile and level with its resolution and aspect ratio, videoprogram identifier (VPID) and the TS identifier (TSID).Next data box contains AUDIO information: type of audio coding (MPEG-1,MPEG-2 or AC-3), audio bit rate, audio program identifier (APID) and language (e.g.spa).The last box located in the same column shows the NETWORK data: networkname and/or satellite orbital position, service name, network identifier (NID) and serviceidentifier (SID).03/2012 Page 83