12' x 26' SUPERMAX™ CANOPY

6. Place Cover and secure to CANOPY FrameA. Place cover over assembled roof frame with grommet panels facing down, aligned with cross rails.B. Make sure the cover is properly aligned on the frame, secure the four corners of the cover with bungees(10066) to the frame first. Attach remaining bungees.Re-adjust bungees position along cross pole as needed to ensure a tight and even fit of the cover to the frame.Grommet Panels for BungeesGrommet Panel10547coverGrommet Panels for BungeesInsert Bungee Cord Through Grommet HoleSecure Bungee Around Plastic BallGrommetPanel10066cover7. Tighten the Cover with Twist TiteA. Wrap the cover's cord with plastic ball and "S" hookat the corners of the cover around the corner leg poles.Insert "S" hook into the hole of the corner leg poles.Twist each leg pole toward the inside of the shelter untilthe cover becomes tight. Twist the leg poles equally toensure the cover stays aligned during tightening.Twist-Tite Tighten Covercover10545ABB. To keep the leg in place, wrap a TwistTite cordaround the cross rail and insert its "S" hook into thelined-up hole of the leg pole and 3-way connector.This will prevent the leg from "untwisting". Do this ateach corner.10543Page 705_29770_0F