All Make Van Product Guide

UNIVERSAL VAN
CHECK YOUR
MEASUREMENTS
1. MAXIMUM WALL HEIGHT
The measurement of the height of the wall
between the floor and where the ceiling curve
starts. Westcan recommends the height of any
unit be at least 4” below this measurement for
full top-shelf utility.
Do not measure in the middle of the van!
2. MAXIMUM DEPTH
The depth from your driver’s side wall to the
edge of the top step by the side door.
Do not measure all the way to the door!
DRIVER’S SIDE ZONES
DRIVER SIDE ZONES
A. PARTITION ZONE
This zone is dedicated to the safety partition.
B. DRIVER SIDE PRE-WHEEL WELL ZONE
From B pillar to the wheel well base. Shelving
unit should stop before wheel well, or be able
to extend into the C zone and over the top of it.
C. DRIVER SIDE WHEEL WELL ZONE
Before adding additional products, ensure the
C zone space is not obstructed with rear door
closures or the curvature of the rear roofline.
PASSENGER’S SIDE ZONES
D. PASSENGER SIDE PRE-WHEEL WELL ZONE
Between the side door step and the wheel well.
E. PASSENGER SIDE WHEEL WELL ZONE
Before adding additional products, ensure the
D zone space is not obstructed with rear door
closures or the curvature of the rear roofline.
F. OPTIONAL: REAR PASSENGER-SIDE DOOR
If there is no door in safety partition, this zone
can be used for accessories like stackable
single drawer units or tote holders.
PASSENGER SIDE ZONES
VEHICLE
MEASUREMENT TABLE
1 2 A B C D E
F
WHEEL WELL
HEIGHT
Your Measurements:
westcanmanufacturing.com 53