C - Ocean Sailing Enterprises
C - Ocean Sailing Enterprises
C - Ocean Sailing Enterprises
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
30<br />
Uso e Manutenzione Avvolgifiocco<br />
Furler’s use and maintenance<br />
■ C-11 Consigli per la vela<br />
Se la barca è fornita di numerose vele, ognuna di<br />
queste dovrebbe avere la stessa lunghezza in<br />
inferitura in modo che la testa girevole si trovi alla<br />
stessa altezza quando la vela è completamente issata<br />
per formare tra drizza e strallo un angolo di circa 10<br />
gradi (vedi C-9).<br />
ATTENZIONE<br />
Quando la vela è armata la testa girevole non<br />
deve mai essere battuta sull'anello di fermo<br />
del terminale. Il carico di trazione che graverebbe<br />
sui profili porterebbe alla rottura dei<br />
giunti di collegamento dei profili stessi.<br />
Il migliore modo per avere la stessa lunghezza di<br />
inferitura è aggiungere uno stroppo in Spectra "Y"<br />
di lunghezza opportuna.<br />
Per stabilire questa lunghezza issare la vela portando<br />
la testa girevole all’altezza corretta e murare la<br />
vela con uno stroppo di lunghezza adeguata per<br />
poter dare alla vela la normale tensione e rilevarne la<br />
misura "X ".<br />
✔ AVVERTENZA<br />
La lunghezza dello stroppo "Y" deve essere<br />
uguale alla lunghezza "X".<br />
ATTENZIONE<br />
Posizionare direttamente lo stroppo "Y" sulla<br />
penna della vela; così non sarà rimosso, perduto<br />
o scambiato.<br />
Y<br />
50<br />
ISTRUZIONI DI MONTAGGIO<br />
INSTALLATION<br />
X<br />
Edit. 11.2002<br />
51<br />
C<br />
■ C-11 Suggestions for the sail<br />
If the boat is supplied with various sails, they should<br />
have all the same hoisting length so that the halyard<br />
swivel is at the same height when the sail is completely<br />
hoisted in order to keep the 10° angle between<br />
halyard and stay (see C-9).<br />
CAUTION<br />
When the sail is hoisted the halyard swivel has<br />
never to touch the lock ring of the terminal foil.<br />
The load that would then weigh on the foils<br />
would break the splice pieces.<br />
The best way to have the same hoisting length is to<br />
add a Spectra collar “Y” of the right length.<br />
You will find out this length by hoisting the sail and<br />
taking the halyard swivel to the correct height. If you<br />
tack the sail with a collar of an adequate length in<br />
order to give the sail the normal tension you will then<br />
find out the measure “X”.<br />
✔ CAUTION<br />
The “Y” collar and the “X” collar have to be equal<br />
in length.<br />
CAUTION<br />
Position the “Y” collar on the sail’s peak, in order<br />
not to remove it or miss it.