Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Troubleshooting<br />
Problems Possible causes Remedy<br />
Engine not starting<br />
Wrong engine running<br />
direction<br />
Splitting knife not moving<br />
Splitter has no power<br />
After being pressed, the<br />
green switching button not<br />
staying in place<br />
Hydraulic pump whistling;<br />
splitting knife running jerky<br />
1. No current in the outlet<br />
2. Defective extension cable<br />
3. Wrong feeder cable<br />
4. Defective switch, condenser<br />
1. Check the network protection<br />
2. Pull out the plug – check it and replace it if necessary<br />
3. Connection with 5 cores with a cross section of 2.5 mm 2<br />
4. Have the appliance checked by an electrician<br />
1. Wrong connection 1. Turn the phase changer in the appliance plug using a<br />
screwdriver<br />
1. Two-hand switching lever adjustment 1. Check the oil level<br />
Defective control valve must be replaced in a service<br />
centre only<br />
1. Wrong rotation direction<br />
2. Too little hydraulic oil<br />
3. Starting rod is bent; the hydraulic<br />
lifter is not pressed to the full extent<br />
4. Wood with too many knots - splitting<br />
knife gets jammed<br />
5. Operating arm is bent<br />
1. Defective fuse, etc.<br />
2. 2 phase running<br />
1. Oil loss, surface is dirty<br />
2. Too little hydraulic oil in the tank<br />
1. Change the rotation direction<br />
2. Add hydraulic oil<br />
3. Check all screws on the starting rod mechanism<br />
Adjust the pull rod (pic. 10/B); by this,<br />
the hydraulic lifter will be pressed to the full extent.<br />
4. Lubricate the splitting knife with fat.<br />
5. Return the operating arm to the starting position.<br />
1. Check the cable<br />
1. Tighten the screwing<br />
Replace the hoses<br />
2. Add hydraulic oil<br />
13
Change language