Untitled - Platon-implant.com

6) Cases of dense boneWhere the bone at the implant site is closely taken up by compactbone, or is covered by 2mm-3mm of compact cortical bone, be sureto prepare the cortical bone layer using special tapping instruments.The need for tap preparation should be determined while evaluatingthe bone quality during drilling, or the implant placement in preparationof the implant socket. Also, where the need for tap preparationwas determined, and the implant placement is stopped once the tappreparation is done, we are asking you to place another new implant.Conduct the tap preparation while controlling bone burns throughsufficient irrigation, and preventing burr formations and clogging withcutting chips due to low speed rotation. Use special tapping instrumentscorresponding to implant sizes.Tapping instrumentsThese are instruments for tap preparation. Because the lengthof the tap part is set longer than that of the self tap provided to theimplants, tap preparation can be performed smoothly, and the implantplacement can be made with a minimum of resistance to implantinsertion. There are two types, for 8-10mm and 12-14mm by theintraosseous length of different sizes ( φ 3.3, φ 3.8, and φ 4.7).Chapter 6 Surgical formø 3.3 ø 3.8 ø 4.7Total length: 25.5mm1.2mmMaterial: Stainless steel (TiN coating)The placement should be made to match the grooves formed bytaps with implant threads.For dense bone, because the accumulation of bone cutting chipsin the implant socket may cause an increase in the placing resistance,place the implant following thorough cleaning of theimplant socket after tap preparation.Where implants are completely placed, prepare the bone up tothe top of the instruments. Also, where placement of the polishedsurface is controlled, prepare the bone based on a lasermark.27 SURGICAL MANUAL FOR PLATON IMPLANT SYSTEM