Untitled - Platon-implant.com

Recommendations

Info

When the round driver interferes in the adjacent tooth, use theround driver mini or the extensions (see “Preparation for placement,”described previously for details).Round driver miniExtensionsWhen interference problems occur even if the above method isused, use the implant holder (L).Chapter 6 Surgical formo After the completion of placement, the hex part (the head of the innerscrew) on the tip of the implant holder is rotated counterclockwise, usinga spanner to release the lock and remove the holder once following the primarystability of the implant is verified.SpannerRatchet×When the round driver interferes in the adjacent tooth, use the round driver minior the extensions (see “Preparation for placement,” described previously for details).When releasing the lock using a spanner, reversing the directionof rotation may break the inner implant because the inner screwof the implant holder is twisted. Therefore, release the lock carefully.39 SURGICAL MANUAL FOR PLATON IMPLANT SYSTEM
When the ratchet interferes with the adjacent tooth, release the lock using aholder key. However, since the placement with the holder key causes distortionor twists, never use it (see “Preparation for placement” described previously, fordetails).Release with a ratchetRelease with a holder keyHolder keySpannerp After the inside of the implant has been thoroughly cleaned withphysiological saline and air-dried, a flat cap is inserted using a hex driver.plant location in the gingival margin orsupragingivallyFlat capFlat capThis is a cap for sealing common usable to all types of implants.If the position of the implant to be placed is predicted to belocated subgingival level, a measurement should be made preoperativelyusing a gingival gauge.Chapter 6 Surgical formø 3.4Material: TitaniumSURGICAL MANUAL FOR PLATON IMPLANT SYSTEM40
Page 2 and 3: Chapter 1 Selection of indicationsC
Page 4 and 5: 3. Fabrication of diagnostic and su
Page 6 and 7: 5. Caution at diagnosis (drills and
Page 8 and 9: 2. Superstructure I Differences amo
Page 10 and 11: 5. Treatment steps (nonsubmerged pr
Page 12 and 13: Chapter 4 Preoperative preparationU
Page 14 and 15: 5) Preparations and points to be ch
Page 16 and 17: Drilling sequence and implant place
Page 18 and 19: Bore twist drills φ 24-28These are
Page 22 and 23: ◆ Correlation chart between taper
Page 24 and 25: Guide pinsThese are used to check t
Page 26 and 27: 4) Optional drillsCircular punch (d
Page 28 and 29: 6) Cases of dense boneWhere the bon
Page 30 and 31: 7) Cases of narrow bone width (knif
Page 32 and 33: 8) Cases where the distance between
Page 34 and 35: 2. Implant placementThe implants ar
Page 36 and 37: ExtensionsWhen tools cannot be inse
Page 38 and 39: 2) PlacementFollowing the completio
Page 42 and 43: Chapter 7 Suture of mucoperiosteal
Page 44 and 45: Chapter 8 Control and managementsdu

Untitled - Platon-implant.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?