Miele Dynamic U1 Allergy PowerLine - SHCF3 - Istruzioni d'uso
Miele Dynamic U1 Allergy PowerLine - SHCF3 - Istruzioni d'uso
Miele Dynamic U1 Allergy PowerLine - SHCF3 - Istruzioni d'uso
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
en<br />
Lift the handle out of its holder to access<br />
the telescopic suction tube (dia.<br />
17).<br />
To increase stability turn the elbow<br />
joint at the bottom of the hose downwards<br />
as illustrated until it clicks into<br />
position above the retainer (dia. 16).<br />
One part of the telescopic suction tube<br />
is packed inside the other, and it can be<br />
adjusted to suit your height for comfortable<br />
vacuuming.<br />
Press the release button and adjust<br />
the telescopic suction tube to the desired<br />
height (dia. 18).<br />
For normal vacuum cleaning, the<br />
parts of the telescopic tube must be<br />
pushed back together and hooked<br />
back into position.<br />
Make sure the handle is correctly<br />
hooked into its holder on the vacuum<br />
cleaner (dia. 17).<br />
Using the Electrobrush<br />
Recommended use<br />
Please observe the flooring manufacturer's<br />
cleaning and care instructions.<br />
The Electrobrush is particularly suitable<br />
for intensive vacuuming of carpets<br />
which are subject to hard wear. It is<br />
very effective at removing deep seated<br />
dirt and preventing areas of frequent<br />
use being trodden into a path.<br />
Please note that the Electrobrush<br />
should not be used for vacuuming<br />
deep-pile rugs and carpets or valuable<br />
hand-knotted rugs, e.g. Persian<br />
and oriental rugs etc. There is a<br />
danger of the threads being pulled<br />
out. If in doubt, contact the carpet<br />
manufacturer/retailer.<br />
Do not use the Electrobrush to<br />
clean highly variable or uneven<br />
floors. The brush might come into<br />
contact with the floor and cause<br />
damage.<br />
Switching the Electrobrush on and<br />
off (dia. 19)<br />
To use the Electrobrush, you need to<br />
switch it on in addition to the vacuum<br />
cleaner with the button on the<br />
handle.<br />
The Electrobrush indicator light on the<br />
control unit will light up yellow.<br />
This button also enables you to switch<br />
off the Electrobrush during vacuuming.<br />
The Electrobrush will switch itself off<br />
automatically as soon as the vacuum<br />
cleaner is raised to its upright position.<br />
How to use the Electrobrush<br />
To achieve the best results, pass the<br />
Electrobrush slowly backwards and<br />
forwards over the carpet or floor.<br />
For rugs with fringes always draw the<br />
Electrobrush from the middle of the rug<br />
across the fringe towards the floor.<br />
39