MICRON MMX MICRON MMX - Fox

UKMICRON MMXVOLUMECONTROLTurn the knobclockwise to increasevolume, anti-clockwiseto lower volume.TONECONTROLTurn the knobclockwise to raisepitch, anti-clockwiseto lower pitch.ON/OFF PUSHBUTTONPress once to activatethe unit (unit will beepfour times), press onceagain to de-activate(unit will beep once).The LED will illuminatefor approximately 20seconds when the unitSENSITIVITY CONTROLThe MMX has an eight positionsensitivity control. By turning the switchclockwise the unit will decrease insensitivity, anti-clockwise the unit willincrease in sensitivity.Approximate line movement required ateach position to trigger unit.1 = approx 8mm2 = approx 16mm3 = approx 24mm4 = approx 32mm5 = approx 40mm6 = approx 48mm7 = approx 56mm8 = approx 64mmEXTENSION BOXSOCKET2.5mm socket to accept Micron TXRRemote System or Micron XB ExtensionBoxes. (PLEASE NOTE to be used inconjunction with Micron Extension leads)TRANSITA hardcase designed to snap over theMicron MMX giving total protectionwhilst in transit is available allowing youto leave the Microns on the buzzer bar ifyou wish, and eliminating the risk of theOn/Off switch being accidentallyswitched on.DRYING OUT AFTERUSE IN HEAVY RAINThe Micron MMX has been designed tobe weatherproof. However, after use inheavy rain, it is important to allow theunit and most especially the batteries, todry out properly by removing thebatteries and leaving the unit in awarm,dry place overnight, with thebattery compartment left open.N.B. NEVER place batteries in a hotenvironment (e.g. on a radiator orDROP BACKFACILITYDifferentiates betweenforward and drop backmovement of the line.Runs and forwardmovement are identifiedby a single tone with theLED illuminated duringmovement and latchingfor 20 secondsafterwards. Drop backsare identified as a twotone sound with a pulsingLED, which remains‘flashing’ for 20 secondsafterwards.The Micron MMX incorporates asophisticated sensitivity control, whichtakes account not only of the amount ofline movement, but also its direction. InLIGHT PIPEall positions except maximum sensitivity,POWER OUTINDICATORthe line must move the prescribed FACILITYExclusive light pipedistance in the same direction, before Allows Fox Illuminated Bite Indicators totechnology offers widerthe unit will trigger. Any movements inbe powered directly from the Micron.viewing angle givingthe opposite direction will re-set theThe Illuminated Indicator will then lightcount, so that by careful use of thegreater visibility to thesensitivity control, it should be possible up when the Micron is activated andangler.to substantially reduce or completely latch for approximately 20 seconds.British Patent Applicationis switched on.eliminate false alarms.heater).No. 9913345.64 5UKMICRON MMX