Bedienungsanleitung - 4mybaby AG

SPIRIT
Removing the hood cover
Folding the chassis
Both hood bars must be removed
from the cover before
washing. (See illustration)
Loosen the screw using a
screwdriver and remove the
press stud. Now pull the cover
bar out of the joint and out of
the hood cover. After washing,
reassemble in reverse order.
When doing this, make sure that each cover bar is
Please unfold the chassis on
pushed into both stitched guides. The front and back
a surface which cannot
bars must not be mixed up.
scratch the front structure of
the chassis. Simultaneously
Unfolding the chassis
pull up both tensioning
sleeves 1 on both sides as
far as they can go. Then
press the handle 2 down. Now you can make the storage
dimensions even smaller by folding down the upper part
of the handle. The transport lock 3 engages on its own.
Please unfold the chassis on a surface which cannot
scratch the front structure of the chassis. Press in the
transport bracing (1) and pull up the handle (2) till the
handle locks (3) engage on both sides.
WARNING: Ensure that all the locking devices
are engaged before use. Red label underneath
the tensioning sleeves must not be visible.
Assembling and removing the wheels
Before assembling or removing
the wheels, press the
locking spring 1. When assembling
the wheels, make
sure that the locking spring
engages properly.
Removing the tilting unit
INT
Press locking spring 1, hold
and remove the complete tilting
unit 2.
Take care during assembly
that the locking spring locks
properly.
11