mitre saw stand de7023, de7033 - Black & Decker

ENGLISHResidual RisksIn spite of the application of the relevant safetyregulations and the implementation of safetydevices, certain residual risks cannot be avoided.These are:– Risk of personal injury by sharp edges andsqueezing .Markings on ToolThe following pictograms are shown on the tool:Read instruction manual before use.Wear eye protection.DATE CODE POSITION (FIG. 1)The Date Code (u), which also includes the year ofmanufacture, is printed into the housing.Example:2010 XX XXYear of ManufacturePackage ContentsThe package contains:1 Mitre saw stand (DE7023 or DE7033)2 Mitre saw mounting brackets (DE7025)2 Work support/stop (DE7024)1 Hardware bag1 Instruction manual1 Exploded drawing• Check for damage to the tool, parts oraccessories which may have occurred duringtransport.• Take the time to thoroughly read andunderstand this manual prior to operation.Description (fig. 1)WARNING: Never modify the powertool or any part of it. Damage orpersonal injury could result.a. Beamb. DE7025 Mitre saw mounting bracketsc. Extension armd. DE7024 Work support/stope. Extension arm end capf. Extension arm lock leverg. Release leversh. Carry handlei. Locking locator clipj. Leg lock leverk. Release buttonINTENDED USEYour mitre saw stand has been designed to extendthe versatility of your DEWALT mitre saw.DO NOT use under wet conditions or in presence offlammable liquids or gases.These mitre saw stands are professional powertools.DO NOT let children come into contact with thetool. Supervision is required when inexperiencedoperators use this tool.ASSEMBLY AND ADJUSTMENTSWARNING: Always observe the safetyinstructions and applicable regulations.Preparation (fig. 2)1. Place the mitre saw stand on the ground withthe folded legs facing up.2. Depress the leg lock lever (j) or release button(k) and pull leg up until the locking pin clicks intoplace. Repeat on each leg.3. Lift the stand by the center beam and place it inan upright position. The stand should be stableand should not rock.NOTE: Ensure all locking pins are engaged and thelegs are locked in place.DE7024 Work Support/Stop (fig. 3, 4)a. The work support/stop (d) has a clamp (l)to capture the beam and keep it from beingknocked off the beam by your material.The knob (m) may be locked by turningclockwise and the work support/stop is freeto be repositioned when the knob is turnedcounterclockwise. Do not overtighten; firmpressure on the knob will hold the stop in place.b. Adjust the height of the work support/stop (d)by loosening the knobs on both sides (n) andraise or lower the top surface to align with astraight edge or level to the saw table. Tightenthe knobs.NOTE: If the work support height adjustmentslips down when under a load, the weight limitof the work support has been exceeded. Thisweight limit is limited by the tightness of the19