You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
_M150L.book Seite 32 Dienstag, 10. März 2009 6:47 18<br />
Mounting the monitor<br />
6.3 Creating clean soldering joints<br />
M150L<br />
Proceed as follows to solder a cable to the original cables (fig. 7, page 5):<br />
➤ Strip approx. 10 mm of insulation from the end of the original cable (A).<br />
➤ Strip approx. 15 mm of insulation from the end of the cable to be connected (B).<br />
➤ Wind the cable to be connected around the original cable and solder the two cables<br />
together (C).<br />
➤ Insulate the two cables with insulating tape (D).<br />
Proceed as follows to solder two cables together (fig. 8, page 5):<br />
➤ Strip the two cables (A).<br />
➤ Place a shrink sleeve with a length of approx. 20 mm over the cable (B).<br />
➤ Twist the cables together and solder them (C).<br />
➤ Place a shrink sleeve over the soldered point and heat it briefly (D).<br />
7 Mounting the monitor<br />
7.1 Tools required (fig. 1, page 3)<br />
For installation and assembly you will need the following tools:<br />
• Measuring ruler (4)<br />
• Centre punch (5)<br />
• Hammer (6)<br />
• Drill bit set (7)<br />
• Drill (8)<br />
• Screwdriver (9)<br />
To make and test the electrical connection, the following tools are required:<br />
• Diode test lamp (1) or voltmeter (2)<br />
• Insulating tape (10)<br />
• Heat shrinking sleeve<br />
• Hot air blower (11)<br />
• Crimping tool (12)<br />
• Soldering iron (optional) (13)<br />
• Solder (optional) (14)<br />
• Cable bushing sleeves (optional)<br />
Depending on the individual installation requirements you may require bolts, nuts,<br />
washers, self-tapping screws and cable binders other than those including in the scope<br />
of delivery.<br />
32