PerfectCharge W2000 - Waeco

W2000.book Seite 41 Montag, 5. November 2007 6:00 18PerfectCharge W2000Using the battery chargereCautionTo charge the batteries, proceed as follows:➤ Connect the battery charger (chapter “Connecting the batterycharger” on page 38).➤ Set the switch (fig. 7 6, page 5) to the required voltage (“12 V”or “24 V”).➤ Set the switch (fig. 7 4, page 5) to “Charge”.– risk of damageIf the red “Reverse polarity” LED (fig. 7 1, page 5) lights up youhave connected the battery terminals incorrectly.Switch off the battery charger and reconnect it correctly.✓ The automatic charging process starts.✓ The blue charging display (fig. 7 2, page 5) displays thecurrent charging status of the battery.The charging display consists of three LEDs that show thecharging status of the battery:DisplayExplanationLower LED flashesThe battery is almost flatLower LED is lit, central LEDflashesThe battery is approx. 40% chargedLower and central LED are lit,upper LED flashesCharging is roughly 90% completeAll three LEDs are litThe battery is fully chargedWhen the battery is fully charged, the chargerswitches conservation charging mode (pulsecharging)41