Instrucciones de montaje - Waeco

CA-800-Install.book Seite 31 Mittwoch, 20. Februar 2008 12:28 12CoolAir✓InstallationThe first digit of the display (see fig. 7 on page 5, Pos. 5) shows themenu level and the second and third show the parameter which canbe set – for example, 1.17 for menu level 1 and a set value of 17 °C.If you make no entry on the control panel for 60 seconds, the system quitsconfiguration mode and switches off.➤Press the ON/OFF button to quit configuration mode.6.3.2 Menu level 1: Set temperatureThe system always starts with a defined value for the room temperature.This parameter can be configured between 17 and 30 °C:➤✓➤➤✓➤✓✓Start configuration mode (see chapter "Start and end configurationmode" on page 30).The first digit of the display (see fig. 7 on page 5, Pos. 5) shows themenu level and the second and third show the parameter which canbe set.Press the operating mode button (see fig. 7 on page 5, Pos. 4) tochange the parameter.Use the + or - buttons (see fig. 7 on page 5, Pos. 6 and 7) to select thetemperature (in °C) with which the system starts.The digits in the display flash until the parameter you enter is confirmed.Press the operating mode button (see fig. 7 on page 5, Pos. 4) toconfirm your entry.The set value is saved and is then used when the system is restarted.You are now in menu level 1 and can use the + and - buttons to switchbetween menu levels.6.3.3 Menu level 2: Low-voltage cut-offThe battery monitor protects the battery from discharging too low.When the the battery monitor switches the device off, the battery only hasa proportion of its charging capacity. Avoid starting repeatedly or operatingelectrical consumers. Ensure that the battery is recharged. As soon as therequired voltage is available, you can restart the system.If the roof air conditioner only has the supply voltage set here, the systemis switched off.➤Start configuration mode (see chapter "Start and end configurationmode" on page 30).31