ECANTools software user manual

Weitere Magazine

Empfehlungen

Info

Shenyang Guangcheng Technology CO.,LTD.If you need the special baud rate, please choose user-defined. Some special baud ratevalues are shown in the following table.Baud rate Parameter83.3kbps 27C01766.6kbps 2DC01360kbps 2BC01835kbps 2EC02333.3kbps 2EC02525kbps 2FC02F12kbps2BC07C7Automatic identification of the baud rate8Confirm button: after selecting the baud rate, click the button and open the software.Then the SYS indicator light of the device will be blinking. After the successfulconnection, the parameter of CAN-Bus will be shown as below:ECANTools software user manual6
Shenyang Guangcheng Technology CO.,LTD.3.2 Automatic identification of the baud rateIf users don't know the baud rate, you can choose automatic identification of the baudrate. There are two modes of the function, silent mode recognition and enhancedmode recognition. The environment for silent mode recognition requires active CANdata on the bus. The CAN-Bus has at least two devices under test and cancommunicate with each other normally. The environment for enhanced moderecognition are the CAN device must be powered on and the CAN channel is workingproperly. It does not require the device to actively send CAN data, nor does it requireactive CAN data on the bus. Please make sure the connection is correct and two 120ohms resistance is on the CAN-Bus.Please note that for the CAN-Bus system of the car, please select "silent moderecognition" to identify the baud rate. Using "enhanced mode recognition" may resultin vehicle instrument error reporting.There we use USBCAN-II Pro to detect unknown baud rate of other equipment. Thewiring method is CANH to CANH, CANL to CANL and the resistance dial switchhas been switched down. Then open ECANTools.ECANTools software user manual7
Seite 1 und 2: ECANToolsCAN debugging softwareUser
Seite 3 und 4: Shenyang Guangcheng Technology CO.,
Seite 5: Shenyang Guangcheng Technology CO.,

ECANTools software user manual

Erfolgreiche ePaper selbst erstellen

Template löschen?

Als Template speichern?