ETN 162 3 D,GB,F,NL,PL,RU - Eibenstock

auto-stop brushes
In order to protect the motor, this power tool is equipped with auto-stop
brushes. When the carbon brushes are worn out, the machine switches
itself off. In this case both brushes must be replaced at the same time with
original brushes by an electrical specialist.
Warranty
According to the general supply conditions for business dealings, suppliers
have to provide to companies a warranty period of 12 months for redhibitory
defects. (To be documented by invoice or delivery note).
Damage due to natural wear, overstressing or improper handling are
excluded from this warranty.
Damages due to material defects or production faults shall be eliminated
free of charge by either repair or replacement.
Complaints will be accepted only if the tool was returned in non-dismantled
condition to the manufacturer or an authorized Eibenstock service centre.
Declaration of Conformity
On sole responsibility we declare that this product is in conformity with the
following standards and standard documents:
EN 60 745, EN 55 014, EN 61 000,
according to the regulations 73/23/EWG, 2004/108/EG, 2006/42/EC
Elektrowerkzeuge GmbH Eibenstock
Lothar Lässig (Genaral Manager)
15.06.2012
In addition there is a service indicator on the operating
handle which indicates in advance that the machine is
about to shut down due to worn carbon brushes.
After the indicator lights up, you can use the tool for
approximately 1 day. Then the carbon brushes should
be replaced.
30