User manual for force feedback yoke (english) - Flight illusion

The Yoke has at maximum 6 switches. When a switch is activated in Running mode, the
square of the related switch will change from green to red. Using the Pull Down menue a
function can be assigned to that switch. To save the switch setting it is needed to pust the
Set switch in this frame
14. Follow AP/Servo Mode Status
This frame shows the actual status of the Yoke when externally controlled. It can follow
the auto pilot, the master yoke in case it is in slave mode or the simulator when controls
are done in another manner. The commanded position (where the yoke should go) is given
in the + and – percentages.
15. Configuration Servo Mode
In this frame can be selected what the yoke should do when in Slave mode. It can either
follow the master yoke or follow the autopilot.
12