European Technical Approval ETA-10/0425 - Etanco

Page 24 of ETA-10/0425, issued on 13.12.2010, English translation prepared by ZAG
Base material hollow masonry: Hollow clay brick Leopard Brique Perforèe category 1-HD
Table 15.1: Brick data
Description of brick
Type of brick
Hollow clay brick -
Leopard BP category 1-HD
Bulk density ρ ≥ [kg/m 3 ] 1,3
Standard EN 771-1
Producer of brick
Pacema Groupe Wienerberge
F- 67087 Strasbourg
Format (measurement) [mm] ≥ 220/120/54
Minimum thickness of member hmin [mm] 120
Table 15.2: Installation parameters
Anchor size FM-X5 10
Drill hole diameter d0 [mm] 10
Cutting diameter of drill bit dcut ≤ [mm] 10,45
Depth of drill hole to deepest point h1 ≥ [mm] 80
Drill method [-] Rotary drilling
Overal plastic embedment depth hnom = [mm] 70
Diameter of clearance hole in the fixture df [mm] 10,5
1)
Table 15.3: Characteristic resistance FRk for single anchor
Hollow clay brick - Leopard BP category
1HD fb ≥ 30 MPa
Characteristic resistance FRk
Anchor size FM-X5 10
24°C 3) /40°C 4) [kN] 1,5
50°C 3) /80°C 4) [kN] 0,9
Partial safety factor γMm 2) [-] 2,5
1) Characteristic resistance FRk for tension, shear or combined tension and shear loading. The characteristic resistance is valid for
single plastic anchor or for group of two or four plastic anchors with a spacing equal or larger than the minimum spacing smin
according to Table 18. The specific conditions for the design method have to be considered according to chapter 4.2.1.5 of the ETA.
2) IN absence of other national regulations
3) Maximum long term temperature
FM-X5
Hollow masonry: Hollow clay brick -
Leopard BP category 1-HD
Brick data, installation parameters, characteristic
resistance
Annex 13
of the European Technical
Approval
ETA–10/0425