UltraBEAM Mezzanine Floors - Le groupe Hadley

UltraBEAMSYSTEMS
1
CONTENTSINTRODUCTION DESIGNSOFTWARE
3 SECTION PROPERTIES
4 SECTION DIMENSIONS
5 FLOOR SYSTEMS
6 INSET CLEATS
7 TOP CLEATS
FLANGE FIX SYSTEM
TIE BARS
COUNTERFORM HOLES
8 HOLE CONFIGURATIONS
9 MASONRY CONNECTIONS
PRIMARY RESTRAINTS
10 CEILING GRID SUPPORT
11-12 FLOOR SYSTEMS LOAD TABLE
SINGLE SPANNING
13-14 FLOOR SYSTEMS LOAD TABLE
DOUBLE SPANNING
POINT LOAD CALCULATIONS
STRUCTURALSECTIONSFRAMING
15 SECTION PROPERTIES
16 SECTION DIMENSIONS
17 EXTERNAL WALLS
BRACING STRAPS
BLOCKING DETAIL
18 NON CONTINUOUS INFILL SYSTEM
19-20 CONTINUOUS SYSTEM
21 WALL CONSTRUCTION
22 FLOOR JOISTS
23 EXTERNAL WALLS SPAN TABLES
24 INTERNAL WALL STUD CAPACITIES
FLOOR JOIST SPAN TABLES
25 INDUSTRIAL PARTITION WALLS
26 INDUSTRIAL PARTITION WALLS SPAN
TABLES
www.hadleygroup.co.uk
INTRODUCTION
UltraBEAM cold roll-formed sections are manufactured
in Great Britain by Structural Sections Limited.
UltraBEAM profiles are authenticated by the Steel
Construction Institute and have been designed and
developed by The Hadley Group specifically for
structural engineering applications.
Extensively utilised in construction projects, the
UltraBEAM range of sections offer designers
unparalleled opportunities to optimise building
construction utilising lightweight pre-galvanised steel
structural sections as individual components or
combined within our Structural Sections Framing-SSF.
TECHNICAL SUPPORT
Engineering and design solutions using UltraBEAM
sections and accessories are supported by Structural
Sections’ Technical Department and UltraPRO. Design
Software.
QUALITY ASSURANCE
BS EN ISO 9000: 2000
COSTING
Design and costing to client’s specification ensures
optimum use of material and reduced cost.
AUTHORITY
BS5950 pt 5 1987 supported by test programmes
administered and authenticated by the SCI under The
SCI Light Gauge Accreditation scheme SCILGA.
DETAILING AND ORDERING
UltraBEAM products are available on 3D modelling
systems by StruCAD, XSteel-3D and HyperSteel.
Data transfer of detailing information may be by
electronic data transfer via the Internet or hard copy.
In-built data checks minimise the risk of incorrect data
transfer to the manufacturing process.
UltraPRO
UltraPRO. DESIGN SOFTWARE
UltraPRO. Design Software is produced to facilitate
the rapid and accurate selection of Structural Sections
Limited products. Developed ‘in-house’ and supported
by Hadley Group engineers, UltraPRO. Design Software
is maintained at the leading edge of software
technology.
UltraPRO. Design Software together with a
demonstration of its wide range of innovative features
is freely available upon request. Our philosophy of
constant product development ensures that features
incorporated in UltraPRO. Design Software are
constantly being expanded and increased.
Users are therefore advised to contact Structural
Sections Limited at regular intervals to ensure they
have access to the latest design tools for our products.
UltraBEAM ® and UltraPRO. ® are registered Trade
marks of Structural Sections Limited.