PressureGuard Installation Manual - Fleet Air

Recommendations

Info

1-5 Install the 1/4” Tube x 1/4” NPT fitting 3 to the PPV and attach a length of <strong>Air</strong> Line Tubing 7 from the output port of the PPV to the input of the Regulator Assembly 6 shut-off valve. Use Cable Ties 10 14 to secure tubing. 9
Pressure Regulator Assembly Step 2 – Pressure Regulator Assembly 2-1 To protect the Regulator Assembly 6 from rocks and debris, locate an area near the back of the trailer. <strong>PressureGuard</strong> recommends the rear cross member facing the rear. 2-2 Using the Regulator Assembly as a template, drill two holes, and mount the assembly. 10
Page 1 and 2: PRESSURE UARD T I R E I N F L AT I
Page 3 and 4: PressureGuard System Overview Warni
Page 5 and 6: Item # Description 1 2 3 4 5 6 7 8
Page 8 and 9: Pressure Protection Valve Step 1 -
Page 12 and 13: Wheel End Preparation Step 3 - Whee
Page 14 and 15: 3-5 Repeat steps 3-1 through 3-4 on
Page 16 and 17: 4-2 Tap each hole using a 1/8” -2
Page 18 and 19: Axle Air Line Installation Step 5 -
Page 20 and 21: 5-5 Slide the Axle Air Line Fitting
Page 22 and 23: 6-3 Screw in and tighten the Axle V
Page 24 and 25: 7-3 Push the tubing into the Spindl
Page 26 and 27: Connecting Air Lines to Regulator A
Page 28: Hubcap Installation / Rotating Shaf
Page 31 and 32: 9-2 Install the provided gasket ont
Page 33 and 34: Connecting Air Hoses to the Tires S
Page 35 and 36: 11-4 Connect the two wires of the W
Page 37 and 38: Pressure Switch Connector (+) ( -)
Page 39 and 40: System Troubleshooting Guide Air le
Page 41 and 42: No air flow through regulator. Prob
Page 43 and 44: Warning light on. Problem: 1. Syste

PressureGuard Installation Manual - Fleet Air

Create successful ePaper yourself

Delete template?

Save as template?