PressureGuard Installation Manual - Fleet Air
PressureGuard Installation Manual - Fleet Air
PressureGuard Installation Manual - Fleet Air
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Spindle Plug <strong>Installation</strong><br />
Step 7 – Spindle Plug <strong>Installation</strong><br />
7-1 Starting with the curb side end of the rear axle, remove the tape, in step 5, from<br />
the <strong>Air</strong> Line Tubing 7 and trim the tubing end with a tubing cutter for a<br />
clean and square cut. If a screw was used to help feed the tubing through<br />
the axle, cut above the screw and discard.<br />
7-2 Cut and install Chafe Guard 8 onto the entire length of tubing from where it<br />
enters the axle to where it attaches to the spindle plug brass fitting.<br />
22