ClamHinge System Install Notes - BOE Fabrication

ePAPER READ

DOWNLOAD ePAPER

boefabrication.com

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

START NOW

Also you’ll want to attach the included stop cable so that it’s ready as seen here:

Recommendations
Info

Preparations should be about complete. Be sure that the heat shield around the exhaust U bend is removed. Other notes; Now is a good time to glue your clam shims to the frame as seen here. Gasket maker or Weather Strip Adhesive works well for this:

Also you’ll want to attach the included stop cable so that it’s ready as seen here:

Page 1 and 2: ClamHinge System Install Notes Impo
Page 3 and 4: 28. Remove rear clam by lifting str
Page 5 and 6: The piece cut-out should look like
Page 7: Rollbar Cover: 20-30 minutes You ne
Page 10 and 11: 2. 3. Install a 2” strip on eithe
Page 14 and 15: which will *eventually* be attached
Page 16 and 17: Now you will tilt the clam! Be care
Page 18 and 19: There are two common ways to deal w
Page 20 and 21: j. k. Now you’re going to detach
Page 22 and 23: Battery Tray The Battery Tray accom
Page 24 and 25: Tilting The only tool needed to til

ClamHinge System Install Notes - BOE Fabrication

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?