ClamHinge System Install Notes - BOE Fabrication

Recommendations

Info

Vehicle Preparation This section in broken into 5 sub categories: • Wheel liners • Rollbar Cover • Gas Lid • Battery Cable • Velcro Wheel Liners: 20-30 minutes The Wheel liners will need to be trimmed and then reinstalled back on the car while the clam is removed. Use heavy scissors or tin-snips for this task. First remove the weatherstrip and then enlarge the relief at the front of the liner, as seen: Next, cut across the molded indention on the rear of the liner as so:
The piece cut-out should look like this: Next, reinstall the weatherstrip: Save the cut out piece, as you’ll install that on the rear clam once it’s back on the car like so:
Page 1 and 2: ClamHinge System Install Notes Impo
Page 3: 28. Remove rear clam by lifting str
Page 7: Rollbar Cover: 20-30 minutes You ne
Page 10 and 11: 2. 3. Install a 2” strip on eithe
Page 12 and 13: Preparations should be about comple
Page 14 and 15: which will *eventually* be attached
Page 16 and 17: Now you will tilt the clam! Be care
Page 18 and 19: There are two common ways to deal w
Page 20 and 21: j. k. Now you’re going to detach
Page 22 and 23: Battery Tray The Battery Tray accom
Page 24 and 25: Tilting The only tool needed to til

ClamHinge System Install Notes - BOE Fabrication

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?