ClamHinge System Install Notes - BOE Fabrication

Recommendations

Info

Drill a hole in the large portion of the liner just behind the relief for the shock mount: Reinstall the big parts of the liner on the car. This step complete.
Rollbar Cover: 20-30 minutes You need to trim the interior Rollbar cover so the clam can slide over it easier. The trimming will *not* be visible when the clam is down. First mark the area to be trimmed and then trim with a razor blade. It will shave off clean and easily with a sharp blade. Do *not* be bashful on the shaving here. Some cars require more shaving than others for easy operation.
Page 1 and 2: ClamHinge System Install Notes Impo
Page 3 and 4: 28. Remove rear clam by lifting str
Page 5: The piece cut-out should look like
Page 10 and 11: 2. 3. Install a 2” strip on eithe
Page 12 and 13: Preparations should be about comple
Page 14 and 15: which will *eventually* be attached
Page 16 and 17: Now you will tilt the clam! Be care
Page 18 and 19: There are two common ways to deal w
Page 20 and 21: j. k. Now you’re going to detach
Page 22 and 23: Battery Tray The Battery Tray accom
Page 24 and 25: Tilting The only tool needed to til

ClamHinge System Install Notes - BOE Fabrication

Create successful ePaper yourself

Delete template?

Save as template?