WATERPROOFING TERRACES AND BALCONIES - Mapei
WATERPROOFING TERRACES AND BALCONIES - Mapei
WATERPROOFING TERRACES AND BALCONIES - Mapei
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
54<br />
Technical Notebook<br />
<strong>WATERPROOFING</strong><br />
<strong>TERRACES</strong> <strong>AND</strong> <strong>BALCONIES</strong><br />
strips of fabric by at least 10 cm and press the fabric with a flat trowel<br />
to make sure it is perfectly buttered. Please note that the first layer<br />
of product must be applied in pitch areas wider than 1.2 metres, so<br />
that when MAPETEx SEL (width 1 metre) is applied, there will be at<br />
least 10 cm per side of MONOLASTIC or MONOLASTIC ULTRA to<br />
guarantee that it forms a continuous layer when the next pitch of product<br />
is applied. 2 hours after applying the first layer in good weather, and in<br />
all cases never before the first layer has completely dried, the second<br />
layer may be applied. Make sure the second layer completely covers<br />
the mesh, and finish off the surface with a flat trowel. After completing<br />
the application cycle of MONOLASTIC or MONOLASTIC ULTRA,wait<br />
at least 2 days before installing the tiles.<br />
FOR READY-TO-USE PRODUCTS<br />
MAPELASTIC AQUADEFENSE is supplied ready to use and does not<br />
need to be mixed. Apply with a long-haired roller, brush or trowel in two<br />
even layers at around 0.4 mm thick per coat for a final thickness of at least<br />
0.8 mm in order to create a robust, flexible continuous film. Make sure there<br />
are no interruptions in the film caused by imperfections in the substrate.<br />
After applying MAPELASTIC AQUADEFENSE wait approximately 4 hours<br />
for curing and then lay the ceramic tiles. Before tiling, carefully check the<br />
surface of MAPELASTIC AQUADEFENSE to make sure it is continuous<br />
and that there are no pin-holes or small craters. If there are such defects,<br />
apply a further coat where they are located. For indications regarding laying<br />
tiles and grouting and sealing joints, please refer to sections 8 and 9.<br />
Fig. 7.16 - Application of a second coat of<br />
MONOLASTIC by trowel on MAPETEX SEL<br />
7.17 - Application of a second coat of MONOLASTIC<br />
ULTRA by trowel on MAPETEX SEL<br />
7.18 - MAPELASTIC AQUADEFENSE applied on a<br />
floor-wall fillet joint before applying MAPEB<strong>AND</strong>