What To Expect From Your New home - You - Pulte Homes

21.4 Window Scratches
and Imperfections
The Builder follows ASTM specifications, a well-known
set of published performance standards, which
state that imperfections in glass can be determined
by visual inspection. The viewer will look through
the window in daylight without direct sunlight. The
potential imperfection must be in the view plane
90° to the window surface. Imperfections must be
detectable from a distance of over 10 feet to be
considered for repair. These kinds of imperfections
will be repaired for a period of 30 days after closing.
21.5 D e f e c t s
The Builder, for a period of one year, will replace
defective glass when defects, including stress cracks
or failed seals in insulated windows, occur.
21.6 Air Infiltration
Some infiltration around windows is normal, especially
during high winds. The Builder, for a period of one
year, will take necessary corrective action by adjusting
windows or weatherstripping if infiltration is excessive.
Section 22:
Electrical
22.1 Fuses Blow or Circuit
Breakers Trip
Fuses should not be blown and circuit breakers
should not be tripped under normal use. The Builder,
for a period of two years, will correct circuit breakers
that trip excessively under normal use.
43
22.2 Electrical Outlets, Switches,
or Fixtures Malfunction
The Builder, for a period of two years, will correct
outlets, switches, or fixtures that malfunction. In
situations where lights dim and flicker, please note
that voltage entering the home is controlled by the
local utility transmission service and may fluctuate
based on variances in power generation and usage.
22.3 Ground Fault Circuit Interrupter
(GFCI) Trips Frequently
Ground fault circuit interrupters are safety devices
installed as part of the electrical system to provide
protection against electrical shock. These sensitive
devices detect potentially dangerous “ground faults”
in small appliances and extension cords. The Builder,
for a period of two years, will replace any failed
GFCI device that fails to reset. The Homeowner is
responsible for repairing any device that causes the
GFCI to trip.
Testing GFCIs
A faulty GFCI can result in serious harm to you
or your family if an accident occurs. Test
each GFCI outlet once a month by following
these steps:
1. Push the TEST button on the GFCI outlet.
The GFCI should trip, resulting in power loss to
the outlet.
2. Reset the GFCI, which should restore power
to the outlet.
3. If the GFCI doesn’t reset, try using a can
of compressed air to blow out any excess dust.
If it still doesn’t reset or it doesn’t trip, have it
replaced by a professional electrician.