Operating and installation instructions Frost-free freezer FN ... - Miele

More documents

Recommendations

Info

Changing the door hinging It is important to check that the side section of the handle d does not come into contact with the door seal when opening the door, as this would damage the door seal permanently. If, after you have refitted the handle, you find that the side section does touch the door seal when the door is opened: ^ Realign mounting plate c with grub screws a until the mounting plate and the side section of the handle d are at the correct angle and the side section does not touch the door seal when the door is opened. 42
The appliance door can be aligned to the housing using the outer long slots in the lower hinge plate. In the following illustration the door is not shown in the closed position to make it easier to see what happens next. ^ Remove centre screw a from the hinge plate. ^ Slightly loosen both outer screws b. ^ Align the door by sliding the hinge plate to the left or right. ^ Then tighten screws b again. Screw a does not need to be refitted. Aligning the appliance 43
Page 1 and 2: Operating and installation instruct
Page 3 and 4: Contents Metal grille at the back o
Page 5 and 6: Disposal of the packing material Th
Page 7 and 8: Technical safety ~ Before setting u
Page 9 and 10: Correct use ~ Never handle frozen f
Page 11 and 12: Normal energy consumption How to sa
Page 13 and 14: It is very important to set the cor
Page 15 and 16: Your appliance has been fitted with
Page 17 and 18: Maximum freezing capacity To ensure
Page 19 and 20: Home freezing Only freeze fresh foo
Page 21 and 22: Never re-freeze partially or fully
Page 23 and 24: This freezer is equipped with a Fro
Page 25 and 26: Metal grille at the back of the app
Page 27 and 28: . . . the alarm sounds and the alar
Page 29 and 30: In the event of a fault which you c
Page 31 and 32: Do not place any appliance which gi
Page 33 and 34: Appliance dimensions A B C Installa
Page 35 and 36: ^ Close the doors to check whether
Page 37 and 38: ^ Push short trim k into the gap at
Page 39 and 40: Changing over the door ^ Close the
Page 41: ^ Fit hinge plate c onto the opposi
Page 48: Alteration rights reserved / 4709 F

Operating and installation instructions Frost-free freezer FN ... - Miele

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?