7.3 - Door - Roll Up Blind.idw - Northern Polytunnels

ITEM 1
ITEM 3
ITEM 2
ITEM 7
ITEM 5
COPYRIGHT © NP STRUCTURES
SECTION 7.3 - ROLL UP BLIND OPTION (OPT-RUB)
PAGE 7.3.1 - PARTS REQUIRED
ROLL UP BLIND PARTS LIST (QTY'S PER DOOR)
ITEM QTY PART NUMBER DESCRIPTION
1 6 FIT-RUBB ROLL UP BLIND FIXING BRACKET
2 12 BF-WS8X15 POZI CSK WOODSCREW 4mm x 40mm LG
3 3 AL-STRAP1MDR ROLL UP BLIND PRE-DRILLED ALITRAP
4 1 SU-CA515PEICE COATED PP CURTAIN
5 3 AL-INFBASE1M PVC "U" PROFILE
6 3 AL-INFTOP1M PVC "T" PROFILE
7 6 BF-RCLIP 40mm LONG CLIPS
ITEM 6
DR-HOBBYPOLY-7.3
VERSION 1.1

5
6
FIG. 7.3.1
CONSTRUCTING THE BLIND
ROLL OUT BLIND AND FIT INTO
ALI TRAP AS SHOWN IN FIG. 7.3.2
AT THE TOP AND BOTTOM OF
THE BLIND.
COPYRIGHT ©
NP STRUCTURES
6
5
3
10mm FROM U/SIDE
OF DOOR FRAME TO
CENTRE OF BRACKET
FIX IN THE MIDDLE ONCE
SECURED ON THE ENDS
3
FIG. 7.3.3
FITTING THE TOP BRACKETS
SECTION 7.3 - ROLL UP BLIND OPTION (OPT-RUB)
PAGE 7.3.2 - CONSTRUCTION & INSTALLATION
485
4
970
6
5
3
qOF DOOR FRAME
6
5
4
3
FIG. 7.3.2
1
2
PUSH THE "T" PROFILE INTO THE
"U" PROFILE TO CLAMP THE
BLIND TO THE ALITRAP
PUSH THE "U" PROFILE INTO THE
ALITRAP. (MAKE SURE THE BLIND
IS STILL FLUSH WITH THE TOP OF
THE ALITRAP)
PLACE BLIND OVER ALITRAP
ENSURING THE BLIND IS CENTRAL
AND FLUSH AT THE TOP WITH THE
TOP OF THE ALITRAP
2
DRIVE 2 OFF ITEM 2
THROUGH THE
BRACKET INTO THE
DOOR FRAME
FIG. 7.3.4
BRACKET FIXING DETAIL
DR-HOBBYPOLY-7.3
VERSION 1.1

FIG. 7.3.5
1. HANG THE BLIND ON THE TOP BRACKETS
AND ALLOW TO DROP.
2. MARK THROUGH HOLES IN ALITRAP ONTO
THE DOOR FRAME AND ATTACH THE
BRACKETS (ITEM 1) IN PLACE
SECTION 7.3 - ROLL UP BLIND OPTION (OPT-RUB)
PAGE 7.3.2 - INSTALLATION
INSERT CLIP INTO
HOLE IN BRACKET
TO SECURE BLIND
COPYRIGHT ©
NP STRUCTURES
TO OPEN DOOR WAY UP FULLY
ROLL THE BLIND UP TO EACH
ALITRAP AND SLIDE ONTO THE
TOP BRACKETS
7
FIG. 7.3.6
SECURING THE BLIND
FIG. 7.3.7
BLIND IN THE "UP" POSITION
DR-HOBBYPOLY-7.3
VERSION 1.1