Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2- INSTALLATION<br />
2.1 - Removing transit bolts<br />
A<br />
B<br />
C<br />
2.2 -Plumbing connection<br />
After removing the external packing<br />
the drum must be released before the<br />
machine is used.<br />
This is done in the following manner:<br />
1.) Unscrew and remove the four<br />
screws A-B-C-D.<br />
2.) Push with a screwdriver at an angle<br />
in the screw holes until the four spacers<br />
(H) fall.<br />
These must be recovered and kept.<br />
3.) It is very important to recover these<br />
four spacers (H) because they could<br />
cause damage if they remain inside the<br />
machine and also because they will be<br />
required to move the machine in the<br />
case of moving house.<br />
The user will require a tap with a 3/4" gas screwthread outlet and a drain<br />
situated between 50 and 80 cms. above floor level. The watermain pressure<br />
must be between 0,4 and 10 bar inclusively.<br />
Proceed as follows:<br />
-Let the water run for a while before connecting the hose.<br />
-Connect the water inlet hose applying the rubber joint provided in the fittings<br />
equipment bag.<br />
-Position the drainage hose inside a hose of a larger diameter, or rest it well<br />
fastened against any kind of drain at the height indicated.<br />
-Neither of the hoses should be twisted or kinked.<br />
- Use new tubes for connecting to the water supply.<br />
Max.80 cm.<br />
D<br />
Min.50 cm.<br />
H<br />
H C<br />
THERMO<br />
H<br />
C<br />
C- Cold water connection.<br />
H- Hot water connection.<br />
The "H" connection can only<br />
be applied in those machines<br />
fitted for this (Bithermical).<br />
5
Change language