Download - Graupner

More documents

Recommendations

Info

The figure shows the assembled aileron linkage. Please note that the servo level length should be at least 12 mm to keep the clevis from colliding with the wing. The figure shows the servo lead exiting at the wing root. Later, use the CRP tube Ø 8x280 mm to push the halves of the wing onto the fuselage. Fuselage and tail group First place the motor spindle, motor mount, and locking ring onto the motor; these parts are included as accessories in the package for Order No. 7738. The figure shows the individual parts for the motor spindle and motor mount; tighten all screws. The figure shows the motor with attached motor mount and motor spindle. Separate the motor leads and remove about 5 mm of insulation. Apply solder to the ends of all leads and then solder on the G 3.5 connectors (included with Order No.7738). Insulate the connector shaft with the heat-shrink sleeves (included with Order No.7738) . Use a hair dryer to shrink the heat-shrink sleeve. Then do a test run of GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Modifications reserved! No liability for printing errors! 10/2011 - 4 -
the motor. Viewed in flight direction, the motor should rotate to the right; if this is not the case, switch any two of the leads and re-insert. Using the 4 M 3x10 mm and the washers and locking rings shown, screw the motor in tight. Place the GRP propeller spacer onto the propeller, enlarge the cut-outs in the spinner cap to fit the propeller, separate the two short pins on the spinner back plate, so that the spinner cap fits and can be pushed on without any stress. GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY Modifications reserved! No liability for printing errors! 10/2011 - 5 -
Page 1 and 2: ASSEMBLY INSTRUCTIONS Order No. 935
Page 3: opposite face. Make sure that no re
Page 7 and 8: Use UHU ALL PURPOSE ADHESIVE Power
Page 9 and 10: The figure shows the right elevator
Page 11 and 12: Decals Cut out the individual decal
Page 13 and 14: the wind. Here at GRAUPNER Modellba
Page 15 and 16: All model fliers should take care t

Download - Graupner

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?